圖片：
圖片：
圖片：
MX Compoent版本為4.06，根據三菱客服回答支持FX3U的以太網連接，F(xiàn)X3U的以太網模塊為FX3U-ENET-L，以太網根絕我自己的理解已經設置好了，在同一網段下已經能Ping到PLC的IP，然后通過MX Component去連接的時候，就報錯了：
Port connetion error
Establishment of connection failed
The other end does not respond.
The corrective action is as follows:
Review the IP address and port number values of the properties.
Review the system, e.g. PLC CPU,module setting and cable status.
Exit the program and restart the IBM-PC/AT compatible.
<ErrorCode:1808008[Hex]>
在MX Component 這邊設置FX3U以太網連接參數的時候沒有端口號設置選項，為什么會這樣，求解決。
滬公網安備31010802001143號
